Command Reference - Huawei IN200 User Manual

Huawei IN200 NIC
User Guide
Major Command
fm_show
sriov
self_adaption
serdes
sfp
reset
lro
xstats
inter_coal
sdi_mode
sdi_cfg
roce_port_traffic
reboot_notice
dcb
pfc
ets

6.1.4 Command Reference

This section describes the meanings, parameters, and usage of the common commands of the
hinicadm tool. For more information about the commands, you can run the -h command on
the hinicadm.
Issue 06 (2019-07-27)
Function
Queries the interrupt information
reported by a hardware module
Queries and sets the PF
virtualization control status.
Queries and sets the port auto-
adaptation mode.
Queries port serdes information.
Queries optical module
information.
Restores factory settings.
Queries and Sets the LRO
Coalesce Time
Queries the statistics of received
and sent packets of a NIC port
Queries and sets the interrupt
coalescence parameters
Queries and Sets the SDI Card
Mode
Queries and Sets the SDI
Configuration
Queries the real-time traffic sent
and received by each port of a NIC
where a RoCE device is located.
Sets NIC Packet Data to Be Sent
and Triggering NIC Packet
Sending When AC Power Is Lost
Queries and sets the DCB
function.
Queries and sets the PFC function.
Queries and sets the ETS function.
Copyright © Huawei Technologies Co., Ltd.
6 Management Tools
Remarks
-
-
-
-
-
-
-
for Windows only
for Linux only
-
for ARM versions of
Linux only
Currently, QoS can be
configured only in Linux.
51