Advertisement
(3-6) CABLE COMPENSATION
Cable compensation mode can be selected.
SHORT
MIDDLE
->
(Factory setup is SHORT)
SHORT: From 0 to 100 meters the length of the cable
MIDDLE: From 100 to 300 meters the length of the cable
LONG: From 300 to 500 meters the length of the cable
These modes adjust the output in proportion to the length of the cable.
NOTE : Cable specification(5C-2V)
(3-7) MASKING
This camera contains MASK function.
MASKING
MASK
MASK COLOR
MASK EDIT
MASK ERASE
RETURN
MASK
The mask display can be switched ON or OFF on the monitor screen.
MASK COLOR
The color of the mask is set.
BLACK
WHITE
MASK EDIT
The area of a mask can be edited. It is possible to make up to 8.
Editing procedure
1. Move the cursor to MASK and select ON.
2. Move the cursor to MASK EDIT and press the SW. MASK SETTING menu is displayed.
3. The pointer is displayed on the monitor screen. The area of a mask can be edited by using this
pointer. At first, move the cursor to the upper left position you want to make a mask and press the
SW. Next, move the cursor to the lower right position you want to make a mask and press the SW.
In the above procedure, a mask can be made.
MASK ERASE
The made mask is erased.
Erasing procedure
1. Move the cursor to MASK ERASE.
2. The made mask is erased by pressing the SW.
Note) When two or more masks are made, the mask is erased contrary to the making order.
En-19
LONG The mode turns in this order.
->
ON
BLACK
END
Fig.9-6 MASKING menu
GRAY → RED → GREEN → BLUE → YELLOW
MASK SETTING
SELECT START POSITION
NOW POINT = ( 088,051)
Advertisement
