Advertisement
(2-1) ECLIPSER
The ECLIPSER function is set.
ECLIPSER
ECLIPSER
THRESHOLD
LEVEL
RETURN
Fig.8-2 ECLIPSER menu
ECLIPSER
Select one of the following Eclipser options:
ON When using Eclipser settings.
OFF When not using Eclipser settings. (Factory setup is OFF .)
THRESHOLD
The threshold of the brightness of the corrected subject can be adjusted..
The range is 0 to 25.
LEVEL
The intensity level of subject can be corrected..
The range is 1 to 8.
Adjusting procedure
1. Set the function
AGC : OFF
ESC : OFF
BLC : OFF
ECLIPSER : OFF
2. Set the video output level
Video type : Set response selector of auto-iris lens to AVERAGE.
Viewing gray scale (logarithmic) or an object, set video output level of camera to
0.75Vp-p by adjusting LEVEL VR of auto-iris lens.
DC type : Viewing gray scale (logarithmic) or an object, set video output level of camera to
0.75Vp-p by adjusting "DC IRIS LEVEL".
3. Viewing an object in front of a bright background.
4. Set "ECLIPSER" : ON
5. Set "LEVEL" to 4 or 5.
6. Adjust the "THRESHOLD" until the object can be seen with good highlight.
7. Adjust "LEVEL" if you want to change the brightness of an object.
(3) FUNCTION SET .
In this menu, functions other than exposure system can be specified.
FUNCTION SET .
SYNC SELECT
WHITE BALANCE
CROMA
GAMMA
APERTURE
CABLE COMPENSATION
MASKING
TITLE
RETURN
Fig.9-1 FUNCTION SET . menu
ON
17
4
END
AUTO
0.6
SHARP
SHORT
END
En-16
Advertisement
