Connect The System To The Network - Dell DP4400 Hardware Installation Manual

Connect the system to the network

Figure 7 Installing the front bezel
The following figure shows the location of the DP4400 network ports and iDRAC port.
Figure 8 DP4400 network and iDRAC connections
Procedure
1. Use a Cat5e or Cat6 UTP copper Ethernet cable to connect a 1 GbE port (10) to
the service computer.
2. If the DP4400 contains 10Gb BASE-T network cards, use Cat6a UTP or Cat7
copper cables to connect to the network switch.
3. If the DP4400 contains 10GB SFP network cards, use fiber cables with a 10 Gb
optical SFP, 1GBaseT RJ-45 SFP with Cat5e or Cat6 UTP copper Ethernet
cables, or direct-attached copper cables to connect the four required 10 GbE
ports (2, 3, 8, 9) to access ports on the switch in your network.
Connect the system to the network
11