NEC IPASOLINK 400 Installation And Provisioning page 98

15. Equipment Setup -> AMR / Radio Mapping Configuration -> Setup, New Setting

AMR Operation enabled = "AMR Mode"

Select modulation levels QSPK, 16QAM

Set the number of E1/STM-1 channels for each modulation level
16. Provisioning –> Modem Function Setting

TX Power Setting: set the MTPC TX power (dBm) as given in the license
17. Provisioning -> E1/STM-1/Cross Connect Setting

enable the required E1-ports

cross-connect the E1 channels
18. Check the NMS connection

ping from the LCT port the NMS server IP address

request pinging test from the NMS server to the NMS port and Bridge1 addresses

request connection to be made to the NMS
19. Provisioning -> ETH Function Setting

enable Ethernet ports

make VLAN settings

make QoS setting
20. Reset PMON counters and the event logs.

Maintenance Control/PMON/RMON FDB Clear

Equipment Utility/Log Clear Function.
Author: Pekka Linna, NEC Finland Oy, +358 400 604747. email: pekka.linna@emea.nec.com
98