Velocity Measurements (Spectral Doppler Mode) - GE Voluson 730Pro Service Manual

GE H - K
EALTHCARE RETZTECHNIK
D , R
IRECTION EVISION
4-4-7 Basic Measurements
4-4-7-4

Velocity Measurements (Spectral Doppler Mode)

NOTE: The Spectral Doppler image is displayed based on time (X-axis) and velocity (Y-axis).
4-4-7-4-1 Acceleration Velocity and Velocity Ratio
1.) Press the CALIPER key once.
2.) Select the appropriate item among VELOCITY or A/B.
3.) Perform the measurement(s) using the TRACKBALL and SET (right or left trackball key).
4-4-7-4-2 Average Velocity (Manual Trace)
1.) Press the CALIPER key once.
2.) Select the MANUAL TRACE item from the menu area. A cursor appears on the screen.
3.) Move the cursor with the TRACKBALL to the start point of the measurement and press SET
4.) Trace to the end of the period and press the SET key again to fix the mark.
Before you complete the measurement:
To readjust the traced line, press UNDO (upper trackball key) repeatedly.
NOTE: Depending on the setting in the Measure Setup, the envelope curve will be performed with a continuous
trace line or by setting points.
4-4-7-4-3 Average Velocity (Auto Trace)
1.) Press the CALIPER key once.
2.) Select AUTO TRACE item from the menu area on the left side of the screen.
3.) Select the SENSITIVITY of the envelope curve (to eliminate artifacts).
4.) Select the TRACE MODE channel of the envelope curve (upper, both, lower).
5.) If necessary, select the Angle and the Baseline.
6.) Press the RIGHT OR LEFT TRACKBALL KEY to finish the measurement.
Before you complete the measurement:
-
-
NOTE: The determination of the envelope curve requires a clear and low-noise record of the Doppler
spectrum. Otherwise the reliability of the displayed measurement results may not be ensured!
DRAFT (A
(cont'd)
(right or left trackball key) to fix the marker.
The measurement results appear on the screen.
It traces the Spectral Doppler image automatically and displays the results.
To readjust the start cycle (vertical yellow line), press CHANGE (upper trackball key).
Press SET (right or left trackball key) to fix the line.
Press the CHANGE key again to readjust the end cycle (vertical green line).
Press SET to fix the line.
Chapter 4 - Functional Checks
28, 2008)
PRIL
V ® 730P / P
OLUSON RO RO
S
ERVICE
V (BT03)
M
ANUAL
4-23