Removing and Replacing Parts : Dell Inspiron 2100
8. Ground yourself by touching the unpainted metal surface of an I/O connector on the
back of the computer.
NOTICE:
While you work, periodically touch the I/O panel to dissipate any static
electricity that might harm components.
Screw Identification
NOTICE:
When reinstalling a screw, you must use a screw of the correct length.
Otherwise, you could damage the hardware. Make sure that the screw is properly
aligned with its corresponding hole, and avoid overtightening.
When you remove and replace components, use the screw placemat as a tool to lay out and
keep track of the component screws.
Screw Placemat
file:///F|/Service%20Manuals/Dell/Inspiron/2100/remove.htm (4 of 44) [2/28/2004 6:49:34 AM]