Removing and Replacing Parts : Dell Inspiron 2100
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and
remove any installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching
an unpainted metal surface on the computer.
NOTICE:
Read
following procedure.
1. Use a scribe to carefully pry the six rubber screw covers out of the six screw holes
located along the top and bottom of the bezel on the front of the display assembly.
2. Remove the six M2 x 3.5-mm screws located at the top and bottom of the bezel on the
front of the display assembly.
3. Separate the bezel from the display-assembly top cover.
The bezel is secured by slot openings that snap into the display-assembly top cover.
Carefully lift the inside edge of the bezel, working your way around the inside perimeter,
to unsnap and remove the bezel from the display assembly.
Display Assembly Latch
file:///F|/Service%20Manuals/Dell/Inspiron/2100/remove.htm (14 of 44) [2/28/2004 6:49:34 AM]
"Preparing to Work Inside Your
Computer" before performing the