Display Assembly And Display Latch - Dell Latitude D600 Service Manual

Back to Contents Page

Display Assembly and Display Latch

Dell™ Latitude™ D600 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Latch
Display Assembly
CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: You must remove the display assembly before you remove the palm rest.
1. Follow the instructions in "Preparing to Work Inside the
2. Remove the keyboard.
3. Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past this position.
4. Loosen the captive screw that secures the display cable to the system board, and release the cable from the four cable-routing clips.
1 M2.5 x 6-mm screws (3)
2 display cable connector
3 display
4 computer base
5 pull-tab
6 connector
Computer."
057HW