Table of Contents
Advertisement
Appendices
Troubleshooting
Before you call for service, please check the problems and solutions described below. If you cannot solve
the problem, contact the nearest authorized dealer.
Power
Symptom
Cause
The unit does not
The unit is not connected to AC
power on when
power.
you press the
1 (on/standby)
switch.
All of the LED
A system error occurred.
indicators on the
front panel (except
the power
indicator) are
blinking.
Shooting
Symptom
Cause
No picture is
The camera head and CCU are not
output from the
securely connected.
camera.
The [System] menu's [Region] option
setting differs from your video
monitor settings.
The [System] menu's [SDI Video
Format] option setting differs from
your video monitor settings.
Camera picture
The camera head and CCU are not
output is distorted
securely connected.
(does not display
properly).
Solution
Connect AC Power.
Remove the power cord and check the camera cable and
connection with other devices.
If the problem persists, contact Sony service representative.
Solution
Check the connection with the camera head.
Correctly set the [System] menu's [Region] setting (see
page 50).
You can also change the [Region] setting as follows.
To set to [NTSC]: Press the
holding down the MENU and V buttons.
To set to [PAL]: Press the
down the MENU and V buttons.
Correctly set the [System] menu's [SDI Video Format]
setting (see page 50).
Check the camera cable connection. Insert the camera
cable's connector fully, and turn the connector ring to
secure it.
55
LOCK button while
LOCK button while holding
Advertisement
Table of Contents
