General Safety Instructions - Beko METPOINT OCV Instructions For Installation And Operation Manual

4.3

General safety instructions

DANGER!
Compressed gas!
Risk of serious injury or death through contact with quickly or suddenly escaping
compressed gas or through bursting plant components.
It is the obligation of the operator to ensure that the connected pressure generator is
protected against the exceeding of the maximum operating overpressure and of the
temperature limits at the METPOINT
with an operating pressure of 40 bar.
Make sure that the system is pressureless prior to integrating the METPOINT
version for the measurement in systems with an operating pressure of 40 bar into the
compressed gas system!
Any installation works must only be carried out on the pressureless system. Only use
fittings and connecting elements that are approved for this application. It is of vital
importance to observe the specifications of the respective manufacturer.
Unpressurise the plant prior to any maintenance or repair works!
Check all connections prior to the initial start-up and retighten them if necessary.
Do not exceed the max. permissible operating pressure (see type plate).
The max. permissible operating overpressure is specified on the type plate and in the
technical data (see "Technical data" section).
Sudden impact through pressure build-up can cause damage and escape of compressed
gas.
Avoid a sudden pressure build-up by operating the valves slowly.
Maintenance, inspection and installation works must be carried out by authorised and
skilled personnel only. Prior to undertaking any measures on the METPOINT
version for the measurement in systems with an operating pressure of 40 bar, the skilled
personnel shall read up on the device by carefully studying the operating instructions. The
operator is responsible for the adherence to these provisions. The respective directives in
force apply to the qualification and expertise of the skilled personnel.
Never make structural modifications to the plant!
Use genuine spare parts and accessories only!
The general safety and accident prevention regulations apply!
DANGER!
Supply voltage!
The operation and maintenance of electrically-powered machines and devices must only be
undertaken by correspondingly qualified and authorised personnel. Prior to carrying out
service measures, no matter which type, the following notes must be considered:
Make sure that no parts of the system are energised and that the METPOINT
be connected with the electric supply mains during service measures.
WARNING!
Unauthorised interventions!
Any modification of the components that has not been checked and approved by the
manufacturer is potentially dangerous and will void any warranty and liability on the
manufacturer's part.
Measurement accessories METPOINT® OCV 40 bar
®
OCV in the version for the measurement in systems
Safety instructions
®
OCV in the
®
OCV in the
®
OCV cannot
7