HP 9000 300 Series Installation Reference page 21

I
CAUTION
I
Turn your computer OFF before installing the monitor.
I
CAUTION
I
Do not obstruct the air vents at the top or sides of the monitor.
Check the voltage select setting.
Your monitor has a voltage select switch. Make sure that the monitor is set to the same
voltage range as the computer.
Install the video cable.
The video cable is black and has an RCA connector on one end and a BNC connector
on the other.
Connect the end with the RCA connector to the video output jack on the computer and
the other end to the monitor.
Install the Speaker Module.
HP 98786A monitor does not have an internal speaker or HP-HIL circuitry, so you will
need to install a Speaker Module.
Installation involves selecting a location for the module, installing a fastener pad and
attaching the module to the pad.
The fastener pad has a pressure-sensitive adhesive backing. The backing must be placed
on a clean, dry and oil-free surface. It should be flat, smooth and non-porous.
Suggested locations are the back or side of the monitor or the edge of a desk. Avoid any
location which interferes with equipment ventilation grilles.
Select a suitable mounting location and remove the paper covering from the back of the
fastener pad. Place the pad at the location and press firmly for a few seconds. Now
attach the module to the fastener pad.
Installing Your System 13