Configuring The Device; Accessing The Compactflash Card - Siemens RUGGEDCOM RX1510 Installation Manual

Device Management
3.2 Configuring the Device
For information about how to connect to the device via the serial console port, refer
to the RUGGEDCOM ROX CLI User Guide for the RUGGEDCOM RX1510.
For information about how to connect to the device via the management port, refer
to either the RUGGEDCOM ROX Web Interface User Guide or the RUGGEDCOM ROX
CLI User Guide for the RUGGEDCOM RX1510.
The management port is a 10/100Base-TX copper Ethernet port with an RJ-45 con-
nector. The following is the pin-out for the management port:
8
Figure 3.2
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch
and access the RUGGEDCOM RX1510 console and Web interfaces via the device's
IP address. The factory default IP address for the RUGGEDCOM RX1510 is
192.168.0.2.
For more information about available ports, refer to
Note
Single-mode fiber ports only support Ultra Physical Contact (UPC) cable connectors.
3.2

Configuring the Device

Once the device is installed and connected to the network, it must be configured. All
configuration management is done via the RUGGEDCOM RX1510 interface. For more
information about configuring the device, refer to the RUGGEDCOM RX1510 User
Guide associated with the installed software release.
3.3

Accessing the CompactFlash Card

The RUGGEDCOM RX1510 features a removable CompactFlash (CF) card that stores
configuration files, firmware (active and backup versions), file-based feature keys
and other system files.
20
1
RJ-45 Management Port
Pin Name
1 RX+
2 RX-
3 TX+
4 Reserved (Do Not Connect)
5 Reserved (Do Not Connect)
6 TX-
7 Reserved (Do Not Connect)
8 Reserved (Do Not Connect)
"Modules (Page
Installation Manual, 12/2019, C79000-G8976-1055-16
Description
Receive Data+
Receive Data-
Transmit Data+
Transmit Data-
https://-
25)".
RUGGEDCOM RX1510