Accessories And Attachments - DeWalt 399080-02 Instruction Manual

399080-02 rev 11/15/02 10:13 AM
MULTIPLE SIDE HANDLE POSITIONS
The side handle can be properly positioned in five locations based
on personal preference and application. The side handle must be
used at all times to maintain proper control of the tool.
RUBBER BUMPER
The gear case rubber bumper may wear with
use. The bumper can be replaced with part
number 397711-00 available at extra cost
from D WALT authorized service centers.
E
Replacement should be performed by
D WALT authorized service centers or
E
qualified service personnel.
SPINDLE LOCK
The spindle lock pin is provided to prevent the
spindle from rotating when installing or removing
wheels. Operate the spindle lock pin only when
the tool is turned off and unplugged from the
power source. To engage the lock, depress the
spindle lock button (C) and rotate the spindle
until you are unable to rotate it further.
CAUTION: Never depress the spindle lock button while the grinder
is running. Never turn on the grinder while the spindle lock button is
depressed. Damage to your tool or personal injury may result.
SOFT MOUNT
The grinder is equipped with a soft mount, enabling easy wheel
installation and removal.

Accessories and Attachments

It is important to choose the correct guards, backing pads and
flanges to use with grinder accessories. See the chart on pages
5–7 for information on choosing the correct accessories.
Page 5
C
Sanding Flap Discs
soft mount
Type 27 guard
D284937/D284939
hubbed sanding flap
disc
NOTE: Wheel size must match guard size; i.e., a new 7" wheel may
not be used with a 9" guard. The bottom surface of wheel must be
inside the bend of the guard lip.
5
soft mount
Type 27 guard
D284937/D284939
backing flange
54339-00
non-hubbed sanding
flap disc
clamp nut
22191-00