Toro Reelmaster 3100-D Edge Series Installation Instructions Manual page 10

2. Slide the non-drive bearing housing and the
excluder seal off the brush shaft
Figure 22
1. Non-drive bearing housing 3. Brush shaft
2. Excluder seal
3. Remove the 2 J-bolts and the nuts
4. Slide the existing brush off the brush shaft
(Figure 23).
5. Loosen the 2 bolts, washers, and nuts securing
the drive-bearing housing to the bearing-housing
mounting bracket
6. Slide the high height-of-cut brush onto the brush
shaft (Figure 23).
7. Clamp the brush onto the shaft with the 2 J-bolts
and nuts previously removed
Important:
Insert the threaded end of the
J-bolts through the outer holes of the brush
shaft while hooking the curved ends of the
J-bolts into the inner holes.
8. Torque the J-bolt locknuts to 2 to 3 N∙m (20 to
25 in-lb).
(Figure
(Figure
(Figure 23).
(Figure 23).
22).
g027201
1. High height-of-cut brush
23).
2. J-bolts
9. Install the excluder seal and the non-drive
bearing housing onto the brush shaft
10. Mount the non-drive bearing housing to the
bearing-housing mounting bracket with the 2
bolts, washers, and nuts previously removed.
Note:
off.
11. Tighten the 2 bolts, washers, and nuts securing
the drive-bearing housing to the bearing-housing
mounting bracket.
10
Figure 23
3. Loosen these bolts.
Be careful not to knock the seal spring
g027202
(Figure 22).