Toro Reelmaster 3100-D Edge Series Installation Instructions Manual page 5

1. Brush cover
Installing the Roller Brush
Assembly
1. Remove the grease fitting for the roller from the
side of the cutting unit that has the roller-brush
housing (Figure 9).
1. Grease fitting
2. Install the 90° grease fitting so that it faces
backward (Figure
Figure 7
2. Bottom drain plug
Figure 8
8).
g009049
1. 6 mm (1/4 inch) spacer
2. Side-plate mounting flange 4. Flange locknuts (remove)
3. Remove the 2 flange locknuts securing each
roller bracket to the side plates
Note:
Do not remove the bolts. Also, remove
any 6 mm (1/4 inch) spacers positioned
on the top side of the side-plate mounting
flange.
4. Position the left or right roller-brush assembly
mounting brackets onto the roller-bracket bolts
(Figure 10).
g031872
1. Left roller-brush assembly
Important:
mounting brackets directly to the top surface
of the cutting-unit side-plate mounting
flange. Do not put spacers between the
5
Figure 9
3. 90° grease fitting
(Figure
Figure 10
2. Roller-brush mounting
bracket
Mount the roller-brush assembly
g031873
9).
g193248