Toro Reelmaster 3100-D Edge Series Installation Instructions Manual page 9

Figure 18
2. Slide the belt cover onto the mounting bolts and
secure the cover with 2 flange nuts
Important:
Do not overtighten the nuts as
damage to the cover may occur.
Figure 19
1. Belt cover
2. Setscrew installed
3. Setscrew removed
3. Lubricate the grease fittings on each of the
roller-brush bearing housings with No. 2 lithium
grease (Figure 20). Wipe off any excess grease,
especially around the excluder seals.
g027197
(Figure 19).
3
Installing the High
Height-of-Cut Brush
(Optional)
(Optional)
Parts needed for this procedure:
—
Procedure
g027198
Install the high height-of-cut brush (sold separately)
when the height of cut is 2.5 cm (1 inch) or more (5 or
more spacers installed below the side plate pad).
1. If a roller brush is installed on the cutting
unit, remove the 2 bolts, washers, and nuts
securing the non-drive bearing housing to the
bearing-housing mounting bracket
and
1. Non-drive bearing housing
9
Figure 20
High height-of-cut brush (optional)
Figure 22).
Figure 21
g031843
(Figure 21
g027200