Table of Contents
Advertisement
3. When mounting set 3, push bracket 3 to the right end to ensure there is enough space for set 2.
4. Adjust the height using the horizontal alignment screws so that set 3 and set 2 are at the same height.
5. Remove the module-protecting Cover on sets 2 and 3.
Remove the module-protecting Cover.
(The protective Cover is attached on all four sides; at this
point, only remove the Cover on the sides where the sets
meet.)
6. Push set 3 toward set 2, then fasten the right and left sides securely using the right/left fixing screws. Similarly,
push set 1 toward set 2, then fasten the sides using the left/right fixing screws.
(Caution: Push the sets gently and slowly to avoid damage due to a collision.)
14
7
Advertisement
Table of Contents
