Fx Series Rfid Readers Rear Panel - Motorola FX7400-22350A30-US Integrator Manual

Port 1
Antenna Ports (Four Ports, Reverse TNC)
FX Series RFID Reader Rear Panel Connections
Figure 2-4
Use only parts provided with the FX Series RFID readers, or Motorola approved/recommended parts.
CAUTION
Substituting other cables or parts can degrade system performance, damage the reader, and/or void
the warranty.

FX Series RFID Readers Rear Panel

FX Series RFID Readers Rear Panel Description
Table 2-1
Port
Antenna Ports
(Reverse TNC)
Reset
GPIO
USB
10/100BaseT
Ethernet
Power
Port 2 Port 3 Port 4
Reset
Two port version: Connect up to two antennas.
Four port version: Connect up to four antennas.
See Table A-1 on page A-2
US/Canada and EU.
To reset the reader insert a paper clip into the reset hole, press and hold the reset button for not
more than 2 seconds. This resets the reader, but retains the user ID and password.
Insert a DE15 serial cable to connect to external devices.
ActiveSync is enabled by default on the USB client port. Use Visual Studio to use the USB port
for development. Use a remote display tool to access the Windows CE graphical interface.
Advanced users can disable and enable ActiveSync via a registry change in Windows CE,
and can create a custom communication protocol on the USB port.
Insert a standard RJ45 Ethernet cable to connect to an Ethernet network with or without POE
capability, or to a local computer.
DC connector connects to a Motorola approved power supply AC adapter (varies depending on
the country). Maximum power 24 VDC, 1.2 A.
GPIO
USB 10/100BaseT Ethernet
GPIO
Description
for the maximum antenna gains and RF output powers for both
Getting Started
24 VD
Power
(with POE)
2 - 5