Pre-Maintenance
Procedures
Note:
Determine the left and right sides of the
machine from the normal operating position.
CAUTION
If you leave the key in the ignition switch,
someone could accidently start the engine
and seriously injure you or other bystanders.
Remove the key from the ignition before you
do any maintenance.
Important:
The fasteners on the covers of this
machine are designed to remain on the cover
after removal. Loosen all the fasteners on each
cover a few turns so that the cover is loose but
still attached, then go back and loosen them
until the cover comes free. This prevents you
from accidentally stripping the bolts free of the
retainers.
Lifting the Machine
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious injury.
Use jack stands when supporting the
machine.
The jacking points are as follows:
•
Left or right side—under the rear wheel motor or
the frame
(Figure
17).
Figure 17
1. Rear jacking points
•
Front—under the frame behind the front wheel
(Figure
18).
1. Front jacking points
g002718
22
Figure 18
g002719