Controls System Maintenance; Adjusting The Lift Lever; Adjusting The Engine Controls - Toro Sand Pro 3040 Operator's Manual

Controls System
Maintenance

Adjusting the Lift Lever

Adjust the detent plate of the lift lever
the attachment does not float properly (follow ground
contour) during operation.
1. Park the machine on a level surface, shut off the
engine, engage the parking brake, and block the
wheels.
2. Remove the 4 screws securing the control panel
to the frame (Figure
Figure 38
1. Control panel
2. Screws
3. Loosen the 2 bolts securing the detent plate to
the fender and the frame.
Figure 39
1. Detent plate
(Figure 39) if
38).
2. Mounting bolts
WARNING
The engine must be running so that you
can adjust the detent plate. Contact with
moving parts or hot surfaces may cause
personal injury.
Keep your hands, feet, face, and other
body parts away from rotating parts, the
muffler, and other hot surfaces.
4. Start the engine.
5. With the engine running and the lift lever in the
F position, slide the detent plate until the lift
LOAT
cylinder can be extended and retracted by hand.
6. Tighten both mounting screws to secure the
adjustment.
Adjusting the Engine
Controls
Adjusting the Throttle Control
Proper throttle operation is dependent upon proper
adjustment of the throttle control. Before adjusting the
carburetor, ensure that the throttle control is operating
properly.
1. Pivot the seat upward.
2. Loosen the throttle cable-clamp screw securing
g002733
the cable to the engine
1. Throttle cable-clamp
screw
2. Throttle cable
3. Swivel
g002734
3. Move the remote throttle-control lever forward to
the F
AST
31
(Figure 40).
Figure 40
4. Stop
5. Choke cable-clamp screw
6. Choke cable
position.
g002722