Cutter-Motor Drain-Line Kit
for TM5490 or TM7490 Trailed Mower
Model No. 111-8083
This kit is for TM5490 or TM7490 trailed mowers with serial number 310000001 and up. It reroutes the cutter-motor drain-line
directly back to the tank to prepare for potential cutter motor replacements.
Before installing this kit, refer to your machine's Operator's Manual for safety instructions and the product overview.
Important: If after reading these instructions you are still unsure of how to install this kit, contact your Authorized
Toro Dealer for help.
Installation
1
Installing the Front Tee
Assembly
Parts needed for this procedure:
1
1/4-inch tee
1
1/4-inch to 3/8-inch adaptor
1
1/4-inch swivel tee
1
1/4-inch cross adaptor
4
Blanking caps
1
3/8-inch hose
1
Cable tie
Procedure
1. Lower the cutting units, stop the engine, remove the
key, and ensure that there is no remaining pressure in
the hydraulic circuit.
2. Assemble the front tee assemblies as shown in
or
Figure
2.
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
Register at www.Toro.com.
3
2
1
Figure 1
TM5490
1. To the front, left cutting
unit
2. 1/4-inch tee
3. To the front, right cutting
unit
1
2
3
8
Figure 2
TM7490
1. 1/4-inch swivel tee
2. To the front, right cutting
unit
3. 1/4-inch cross adaptor
4. To the right, center cutting
unit
Original Instructions (EN)
All Rights Reserved *3394-515* A
Printed in the UK
Form No. 3394-515 Rev A
Installation Instructions
4
5
G028946
4. 1/4-inch to 3/8-inch
adaptor
5. To the 3/8-inch hose
4
5
6
7
G028947
5. 1/4-inch to 3/8-inch
adaptor
6. To the 3/8-inch hose
7. To the left, center cutting
unit
8. To the front, left cutting
unit