Loading An Existing Configuration - Bosch BRS Quick Installation Manual

Bosch Recording Station Appliance
25. Bosch Recording Station starts automatically. Enter the relevant user name and
3.3

Loading an existing configuration

Note:
If you want to load an existing Bosch Recording Station configuration file, you must log on the
BRS Appliance in administrator mode.
To install an existing configuration, proceed as follows:
1.
2.
3.
4.
5.
Bosch Security Systems
password. The user interface is displayed.
Refer to the following documentation/help for information regarding configuration of the
Bosch Recording Station:
– For operating instructions: see the Bosch Recording Station Operating Manual
– For additional configuration information, see Bosch Recording Station Installation
Manual
Click Start, right-click Bosch Recording Station, then click Run as administrator. The
configuration wizard is displayed.
In the Bosch Recording Station – Configuration Wizard dialog box, click Load... to load
an existing configuration file (.prm file).
Note:
It is not possible to load DiBos configurations.
Confirm the warning dialog by clicking Yes.
Select the relevant configuration file and click Open. The system loads the configuration.
Bosch Recording Station starts automatically. Enter the relevant user name and
password. The user interface is displayed.
Note:
We recommend starting Bosch Recording Station in BRSuser mode.
Quick Installation Guide
System Software Setup | en
XMD-0041-VV002 | V1 | 2011.10
23