Table of Contents
Advertisement
Security Escort
Element
Trouble Tamper Text
Trouble Response
Text
Show Points
Show Areas
Create or modify the SE receivers of the SE coordinator using the features of the Point Data.
For configuring Area Data, refer to the Configuring alarm area, page 76 section. The sections
below explain the SE receiver point configuration in detail.
7.8
Modifying an existing SE coordinator entry
If the SE coordinator is already defined in the Transponder database, the [Edit Data] button
is used to modify the data. The information that can be modified is the same when creating a
new SE coordinator entry (see Creating a new SE coordinator entry, page 67).
7.9
Configuring SE receiver parameters
7.9.1
Setting the Point Number
Each SE receiver that is connected to the SE coordinator on its communication bus has a
unique Point Number (address) assigned during the system design process. The Point
Number ranges from 0 to 15. However, Point Number 0 is reserved for the built-in SE receiver
of the SE coordinator. Therefore, SE receiver can only use the Point Number range from 1 to
15. As the devices are connected on the same bus, the Bus Number is always 0. Note that the
Point Number (1 to 15) must correspond to the physical address of the actual SE receivers,
which is configured using the dip switches on the SE receivers' circuit board.
Clicking the [?] button to the right of the Point Number text box opens a dialog window
displaying the Point Numbers in a grid format. The grid provides a quick way to select a Point
Number by clicking the corresponding number button.
Robert Bosch (SEA) Pte Ltd
Central Console, computer setup and programming | en
Usage/Description
This is the text that will be shown in the trouble dialog when the
Remote Key input on the SE coordinator goes into trouble (open).
This is the text that will be shown in the trouble dialog as the action
that the responding individual should take.
Select this option to enter information of the point ("SE receiver",
"Virtual" or "None").
Select this option to enter information of the alarm area.
Technical Reference Manual
69
2018.03 | SE3v1.0 | DOC
Advertisement
Table of Contents
