Table of Contents
Advertisement
Security Escort
Element
[Next]
[Cancel]
10.4.8
Receiver configuration
Once the SE receiver configuration for an SE coordinator has been entered into the
Transponder database, this dialog is used to verify that each SE receiver is working and is
properly addressed in the database. This setup tool identifies errors in the address switch
settings of SE receivers as well as data entry errors in the Transponder database.
Figure 10.24: Receiver configuration dialog
Element
Transponder
BUS 0, point / [?] /
[+] / [-]
[Put this receiver in
setup mode]
Robert Bosch (SEA) Pte Ltd
Usage/Description
Advances to the next SE coordinator in the system.
Cancels the operation and closes the dialog window.
Usage/Description
Select the SE coordinator from the drop down list.
Enter directly or use the grid or forward/backward buttons to
select the SE receiver point number.
This button initiates the setup process by causing both the red and
green LED of the selected SE receiver to light up. The red and
green LED will be flashing. On the Central Console, this button
changes to the [Abort setup for this MUX Point] button in order
to proceed to the next device in the event that one SE receiver is
not set up properly.
Technical Reference Manual
System menus and dialogs | en 199
2018.03 | SE3v1.0 | DOC
Advertisement
Table of Contents
