Table of Contents
Advertisement
208 en | System menus and dialogs
Element
COM
Carrier Det
No CTS
Mon Power
10.4.14
Remote comm port setup
This dialog connects the network, modem and system serial ports to the physical
communication ports on the computer and sets their baud rate.
See Remote comm port setup, page 57 for details.
10.4.15
Remote setup
This dialog sets up the remote access and system serial port parameters.
See Remote setup, page 59 for details.
10.4.16
Remote connection
10.4.17
Pager setup
This dialog sets up remote pager access for troubles (service) and alarms (security).
Figure 10.30: Pager setup dialog
2018.03 | SE3v1.0 | DOC
Usage/Description
The actual physical communication port over which
communications to the transponder will be carried.
If selected, verify that the communications port is not in use before
communicating. Only to be used on half duplex links where Carrier
Detect indicates that the link is in use. This setting is normally
unselected and rarely used.
If selected, do not monitor the Clear to Send before
communicating. This setting is normally selected.
If selected, monitor the Ring Indicator pin to indicate a remote
power supply used on this communication link has not failed. This
setting is normally unselected.
Technical Reference Manual
Security Escort
Robert Bosch (SEA) Pte Ltd
Advertisement
Table of Contents
