Table of Contents
Advertisement
96
en | Configuring equipment using Utility tool
9.
10. To start upgrading the SE transmitter firmware, click the [Start] button. An indicator bar
11. Upon completion of the firmware upgrade, the SE transmitter emits a rapid succession of
12. Perform the transmitter test again within sight of the SE coordinator. Confirm that the
2018.03 | SE3v1.0 | DOC
the firmware that is uploaded at the start, the SE transmitter row will be grayed out and
disabled.
Repeat steps 8 for other SE transmitters if required.
appears on screen to display the progress of the firmware upgrade. The beeping tone
changes to continuous single beep tones. The red and green LED of the SE coordinator
will be turned on for the entire duration of upload. To abort the upgrade, click the
[Cancel] button.
beeping tones for 1 second, indicating that the firmware upgrade is successful. A
confirmation dialog message appears. The red and green LED of the SE coordinator will
be turned off once upload has completed. Click the [OK] button to close the dialog
message, and the indicator bar will disappear.
firmware version is correctly upgraded.
Technical Reference Manual
Security Escort
Robert Bosch (SEA) Pte Ltd
Advertisement
Table of Contents
