Table of Contents
Advertisement
102 en | Troubleshooting coordinators, points and receivers
Element
No Buddy Check Delay
Run buddy check
High speed buddy
check
Show maintenance
alarm
Sound maintenance
alarm
Show maintenance
levels
Show authorized
supervision
Show unauthorized
supervision
Show test levels
Excel test history files
Pager communications
2018.03 | SE3v1.0 | DOC
Usage/Description
If the checkbox is selected, the software does not impose the hour
between buddy checks from the same SE receiver. Normally, this
checkbox is not selected, and should not be selected for live
systems.
This checkbox enables and disables the buddy check feature of the
system. When selected, the Central Console periodically issues a
command (via the SE coordinator) to each SE receiver, to activate
its on-board transmitter. The Central Console then compares the
signals received from neighboring SE receivers to the results of
earlier buddy checks, thus identifying SE receivers, which appear
to have changed sensitivity.
Checking this checkbox allows the buddy check to run as fast as it
can. Normally, only one buddy check transmission is sent each
minute.
Normally, when a maintenance alarm is received from a
maintenance transmitter, the red LED on all SE receivers will flash
for 5 seconds hearing the transmission. If this checkbox is
selected, the SE receiver with the loudest reception level will turn
on both the red and green LED for 5 seconds.
If this checkbox is selected, the SE receiver with the loudest
reception level on a maintenance alarm will turn on its sounder for
5 seconds. Normally, this checkbox is not selected.
Selecting this checkbox causes the Central Console to display the
signal strength measured by each SE receiver as a number (from 1
to 15) inside the SE receiver icon when maintenance alarms are
displayed. Otherwise, the floor number is displayed.
Selecting this checkbox causes the Central Console to supervise
only authorized supervision alarms.
Selecting this checkbox causes the Central Console to supervise
unauthorized supervision alarms.
Selecting this checkbox causes signal strength levels to appear on
the SE receiver icons when displaying tests on the main map
screen. Otherwise, the green test icons are displayed.
Do not select this checkbox in a live Security Escort System. It is
for diagnostic Engineering testing only.
Normally, this checkbox is not selected. If selected, the
communication to the dial-up wide area paging system through the
modem will be displayed on the history screen. This function is
only used to diagnose communication problems to the paging
system.
Technical Reference Manual
Security Escort
Robert Bosch (SEA) Pte Ltd
Advertisement
Table of Contents
