Table of Contents
Advertisement
Security Escort
Element
Automatically send
selected troubles
Phone number
Password
Pager ID
Character limit
Pages per call
Pager group
Baud rate
System name
System phone
Robert Bosch (SEA) Pte Ltd
Usage/Description
If this checkbox is selected, the system sends all the selected
troubles from the Popup trouble filter dialog to the service
pager.
Phone number to be dialed to access the paging service. This
phone number is usually different from the number you would
manually dial to send a page. The paging company assigns this
value.
This is the password that must be sent to the paging service to
send the page. If not required, leave this field black. Usually a
password is not required. The paging company assigns this
value.
This is the ID that identifies the specific pager that this message
is to be sent to. Many times, it is the last 7 digits of the phone
number that you would manually dial to access this pager. The
paging company assigns this value.
This is the maximum number of characters allowed per page.
Default is set to 80 characters. The Security Escort system will
truncate the pager message at this number of characters. The
paging company assigns this value.
This is the maximum number of pager messages allowed per
phone call. Default is set to 4 pages per call. When this number
of messages have been sent, and there are more messages to
be delivered; the Security Escort system will hang up and redial
the paging service to deliver the remaining messages. The
paging company assigns this value.
This is the group of up to 8 pagers that this message is to be
sent to. You may program the individual pager as well as a
group of pagers. The pager group will be sent the page before
the individual.
Select the baud rate that will be used to communicate with the
paging computers. The paging company assigns this value.
This identifies the Security Escort system when multiple
Security Escort systems report to the same service pager. Keep
this field as short as reasonably possible since these characters,
including space character, will be sent before each trouble
message and they are included in the Character limit set above.
If not desired, leave blank.
This will present phone number to be called in response to the
service page. Only use if required since these characters, plus a
space, will be sent before each trouble message. They are
included with the System name in the Character limit set
above. If not desired, leave as blank.
Technical Reference Manual
System menus and dialogs | en 209
2018.03 | SE3v1.0 | DOC
Advertisement
Table of Contents
