Table of Contents
Advertisement
Security Escort
Element
Total transmissions
Missed all receivers
Enable Rec
Point
Hits
Misses
Highest
Average
Lowest
Run test
Spacing
Stop test and reset
counters
Close dialog, does not
stop test
10.4.10
Network status
This dialog shows the status of communications on the network, modem, and system serial
ports.
Robert Bosch (SEA) Pte Ltd
Usage/Description
The total number of times the designated SE receiver transmitted
the test message.
The total number of times where the test transmission was not
heard by any of the designated SE receivers.
This checkbox must be selected for this SE receiver to monitor
the test transmissions.
Select the point (SE receiver) on this SE coordinator to monitor
the test transmissions.
The number of times this SE receiver successfully heard the test
transmission.
The number of times this SE receiver failed to hear the test
transmission.
The left box displays the highest receive level at which the test
transmission was heard. The right box displays the greatest
number of packets heard from a single test transmission.
The left box displays the average receive level at which the test
transmission was heard. The right box displays the average
number of packets heard from a single test transmission.
The left box displays the lowest receive level at which the test
transmission was heard. The right box displays the least number
of packets heard from a single test transmission.
The test only runs when this checkbox is selected. To stop the
test and retain the test values, unselect this checkbox.
This slows the test by forcing this number of seconds between
test transmissions. Normally, this setting is left at the default
value 0 seconds.
Clicking this button stops the test and resets all values.
Clicking this button closes this dialog but does not stop the test
from running. Reopening the dialog displays the current progress
of the test. The test should not be left running unless there is a
specific need, as it generates both RF and system traffic.
Technical Reference Manual
System menus and dialogs | en 203
2018.03 | SE3v1.0 | DOC
Advertisement
Table of Contents
