Table of Contents
Advertisement
188 en | System menus and dialogs
Notice!
If during this loss of communications, an alarm transmission is received by one or more of the
SE receivers attached to the SE coordinator, the SE coordinator activates outputs attached to
it as well as the horns and red LEDs on any of its SE receivers which detected the alarm
transmission. Since the SE coordinator does not have access to the Subscriber database, it
must assume that all transmitters are valid, so even unauthorized (not in the Subscriber
database) transmitters produce audible alarm indications (if the system is set for audible
alarms in the Security Preferences dialog).
10.4.4
Transponder communications
From the Central Console, it is possible to perform detailed diagnostic tests using the
Transponder communications dialog. From this dialog, the operator can request maps
indicating the status of each device connected to a given transponder, and can control
individual devices, turning LEDs, horns, strobes, and sirens on and off. The Transponder
communications dialog appears on the right when it is opened, allowing the History screen to
be viewed while the screen is open. This makes it possible to view the results of map
commands issued from the console.
Figure 10.20: Transponder communications dialog
2018.03 | SE3v1.0 | DOC
Technical Reference Manual
Security Escort
Robert Bosch (SEA) Pte Ltd
Advertisement
Table of Contents
