Basic Setup
Channel setting
Tuning of this unit to broadcast channels can be performed in two ways.
Auto tuning
Programme the tuner to scan only the channels you can
receive in your area.
1) In stop mode, press [SETUP].
Setup
Required Setting
Playback
Display
Recording
Clock
Channel
Disc
Setup menu will appear.
2) Select "Channel" using [K / L], then press
[ENTER].
Setup
Required Setting
Playback
Display
Recording
Clock
Channel
Disc
Channel menu will appear.
3) Select "Auto Tuning" using [K / L], then press
[ENTER].
The unit will start storing channels available in your
area.
Channel
Auto Tuning
Manual Tuning
Move
Wait for several minutes to finish channel storing.
4) Press [SETUP] to exit.
You can select only the channels memorised in this
unit by using [PROG.
/
].
■ To select a channel
You can select a channel using [PROG.
enter the channel using [the Number buttons] on the remote
control.
■ To cancel auto tuning
Press [RETURN] or [SETUP] during scanning.
Notes
• The selection will be affected by how you receive TV
channels in your local area.
• If the auto tuning is cancelled during scanning, some
channels not yet tuned may not be received.
• Sorting of TV channels from P01 to P06 will be performed
automatically as follows.
P01: BBC1
P02: BBC2
P04: CH4
P05: CH5
* If you are using a satellite receiver, turn it on and select
SKY NEWS before commencing tuning.
Manual tuning
Manually tune each channel.
1) In stop mode, press [SETUP].
2) Select "Channel" using [K / L], then press
[ENTER].
3) Select "Manual Tuning" using [K / L], then
press [ENTER].
Manual Tuning
Position
Channel
Decoder
Skip
4) Select "Position" using [K / L], then press [B].
5) Select the position number you want using
[K / L], then press [s].
You can select position numbers 01 to 99.
6) Select "Channel" using [K / L], then press [B].
/
], or directly
P03: ITV
P06: SKY NEWS
P01
1
OFF
ON
EN
29