Commissioning; Operation; Maintenance And Repair; Decommissioning - Bosch Rexroth IMenip Instruction Manual

22/76 Bosch Rexroth AG
7

Commissioning

CAUTION
Risk of damage to persons
and property!
Commissioning of the IMenip
interface module requires basic
mechanical and electrical
knowledge.
Only qualified personnel (see
y
"Personnel qualifications" on
page 16) are authorized to
commission the system.
• Before commissioning, check that all
plug-in connections have the correct seat.
• Once the system has been switched on
and the module has been initialized, it is
then ready for communication on the
network and waits to be connected by the
Ethernet IP scanner.
• The NS LED and MS LED run through a
test sequence following system boot up.
• The ESD file (device master data)
corresponding to the interface module
can be created with the BS350 operating
software.
8

Operation

Operation is not necessary while the system
is running.
IMenip | 3 609 929 B63/2008-09
9 Maintenance and
repair
Cleaning and care
CAUTION
Any dirt or liquids penetrating
the device lead to
malfunctions!
Safe function of the IMenip
interface module is no longer
ensured.
y Always provide for absolute
cleanness when working on
the IMenip interface module.
Maintenance
The IMenip interface module is maintenance-
free if used as intended.
Spare parts
Please refer to the address directory under
www.boschrexroth.com and in chapter
"16 Service and sales" on page 26 for the
addresses of our foreign subsidiaries.
10

Decommissioning

For details about how to disassemble or
replace your IMenip interface module please
refer to chapter "11 Disassembly and
replacement" on page 23.