Commissioning; Operation; Maintenance And Repair; Decommissioning - Bosch Rexroth IMenip2 Installation Instructions Manual

22/28 Bosch Rexroth AG
7

Commissioning

CAUTION
Risk of damage to persons
and property!
Commissioning of the IMenip2 in-
terface module requires basic me-
chanical and electrical knowledge.

Only qualified personnel
(see "Personnel qualifica-
tions" on page 16) are au-
thorized to commission the
system.
• Before commissioning, check that all plug-
in connections have the correct seat.
• Once the system has been switched on
and the module has been initialized, it is
then ready for communication on the net-
work and waits to be connected by the
Ethernet IP scanner.
• The NS LED and MS LED run through a
test sequence following system boot up.
• The ESD file (device master data) corre-
sponding to the interface module can be
created with the BS350 operating soft-
ware.
8

Operation

Operation is not necessary while the system
is running.
IMenip2 | 3 608 870 F34/2017-05
9 Maintenance and
repair
Cleaning and care
CAUTION
Any dirt or liquids penetra-
ting the device lead to mal-
functions!
Safe function of the IMenip2 inter-
face module is no longer ensured.

Always provide for absolute
cleanness when working on
the IMenip2 interface mod-
ule.
Maintenance
The IMenip2 interface module is mainte-
nance-free if used as intended.
Spare parts
Please refer to the address directory under
www.boschrexroth.com and in chapter
"16 Service and sales" on page 26 for the
addresses of our foreign subsidiaries.
10

Decommissioning

For details about how to disassemble or re-
place your IMenip2 interface module please
refer to chapter "11 Disassembly and re-
placement" on page 23.