Siemens Wireless TEC Transceiver Installation Instructions

Wireless TEC Transceiver (TTX)
Product Description
The Wireless Terminal Equipment Controller (TEC)
Transceiver (TTX) communicates with the Wireless
Room Temperature Sensor (RTS) and uses radio
frequency hopping technology. The TTX surface
mounts near the TEC.
Product Numbers
550-205 TEC Transceiver and RJ11 to RJ11
communications cable
550-208 TTX with setpoint/override support and
RJ11 to RJ11 communications cable
Accessories
540-143 Laptop cable (RJ11 to DB9)
550-200 Replacement communications cable
(RJ11 to RJ11)
550-074 Fitting for optionally mounting antenna
through a knockout (5 pack)
NOTE: 3M Scotchlok™ power connectors are
available from W.W. Grainger, Inc. (part
number 4YT73) via the Field Purchasing
Guide.
Related Products
550-660*
550-662* Wireless TEC Room Temperature
550-664* Sensor (RTS)
550-670*
544-790* Sensor base plate
RTS passkey (for demo, commissioning
544-643A
and service mode)
* Add letter suffix to indicate desired color:
A = Desert Beige, B = White (e.g., 544-790B).
Expected Installation Time
38 minutes
Required Tools
•
Lineman's pliers
•
No. 2 Phillips screwdriver
NOTE: Depending on the actual installation, some
of these tools may not be required.
Item Number 129-406 Rev. BA
Installation Instructions
Prerequisites
FCC NOTE: FCC ID TKD550205-001 Grantee
Code 123—Equipment Product Code
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
UL Listed: UL 916 PAZX
Industrie Canada certification:
TTX: 267AS-550205
The manufacturer is not responsible for any radio
or TV interference caused by unauthorized
modifications to this equipment. Such
modifications could void the user's authority to
operate the equipment.
Installation
NOTES:
1. The TTX antenna base is articulated with stops
at 45° increments to facilitate installation. During
TTX installation, point the antenna towards the
space where the RTS is located to minimize any
obstruction in communications.
2. The broadcast direction of the antenna is
spherical.
Mounting Antenna through a Knockout
(optional)
It is possible to remotely mount the TTX antenna so
that it protrudes through the TEC enclosure using a
Heyco® sealtite fitting (part number 550-074). Follow
the installation procedure in the Installation
Instructions provided with the Heyco sealtite fitting.
Document No. 129-406
October 5, 2009
Page 1 of 2