Siemens FPX Installation Instructions

Wireless Field Panel Transceiver (FPX)
(Version 1.x)
Channel
Network I.D.
Figure 1. Wireless Field Panel Transceiver (FPX).

Product Description

The Wireless Field Panel Transceiver (FPX) is
mounted at or near the field panel and is powered by
24 Vac. The antenna can be either mounted directly
to the radio or mounted remotely for installations
where the location of the FPX causes the antenna to
be shielded—for example, when the FPX is mounted
inside a field panel enclosure.
Product Numbers
563-005 Wireless Field Panel
Transceiver (FPX)
(Version 1.x)
563-007 Direct Mount Antenna
563-008 Remote Mount Antenna
Transceivers do not come with antennas.
Antennas must be ordered separately.
Item Number: 563-003, Rev. BA
24 Vac 1.2VA
E H N
Installation Instructions
Accessories
563-027 Pre-terminated Cable Kit
Includes two 14" cables:
– Power
– Communication
Warning/Caution Notations
WARNING:
Personal injury/loss of life may occur if you
do not follow the procedures as specified.
CAUTION:
Equipment damage or loss of data may
occur if you do not follow the procedures
as specified.
Expected Installation Time
10 minutes
Required Tools and Materials
• Electro-static discharge wrist strap
• Small flat-blade screwdriver
• Cordless drill/driver set
Prerequisites
• All wiring must conform to NEC and local
codes and regulations.
• 24 Vac Class II power source is available.
• Any application specific hardware or device
is installed.
Document No. 563-003
January 12, 2007
Page 1 of 4