9. Removing Tilt motor (Motor ass'y)
9-1.
Remove Screws 107 (x4), then remove Camera base 11 and Camera cover 5 .
This is the disassembling procedure after the disassembling of:
1. Removing Base unit: Page 9
2. Removing Rotation unit: Page 9
3. Removing Main board ass'y: Page 10
4. Removing Power board ass'y: Page 11
5. Removing Camera unit and Fan motor ass'y: Page 12
9-2.
Remove Tilt belt (Synchro belt (N180)) 54 while turning.
9-3.
Remove Screws 101 (x2), then remove Tilt motor (Motor ass'y) 152 .
Refer to Step 5-2 through Step 5-4 on page 26, Step 6-1 on page 27 and page 31 through page 34 for
reassembling.
107
Figure of Step 9-1
54
Tilt belt (Synchro belt (N180))
Figure of Steps 9-2 and 9-3
5
Camera cover
11
Camera base
Screws
3x8mm (x4)
107
152
Tilt motor (Motor ass'y)
–16–
101
Screws
3x10 mm (x2)