Table of Contents
Advertisement
15. Installing the parts to Base section
15-1. Set Spring A 57 and Stopper 19 into the groove of Base 2 as indicated by the arrow.
15-2. Install Stopper plate 16 as shown, then tighten Screw 109 (x1).
Torque: 75.6 cN•m (7.7 kgf•cm)
Apply Screw lock after tightening screws.
57
19
Stopper
15-3. Install Safety wire ass'y 154 to Base 2 , then tighten Screws 107 (x2).
Torque: 75.6 cN•m (7.7 kgf•cm)
Apply Screw lock after tightening screws.
15-4. Place Ventilation film 56 as shown after cleaning the place.
107
Screws
3x8 mm (x2)
154
Safety wire ass'y
107
109
Screw
3x6.3 mm
(x1)
16
Stopper plate
1
Spring A
Figure of Steps 15-1 and 15-2
56
Ventilation film
308
Screw lock
(x2)
Figure of Step 15-3
308
Screw lock
2
2
Base
–37–
2
Base
56
Ventilation film
FRONT
Figure of Step 15-4
Advertisement
Table of Contents
