Table of Contents
Advertisement
9. Reassembling Camera unit
9-1.
Install Camera support 12 to the right of Camera 64 , then tighten Screws 104 (x2).
Torque: 21.2 cN•m (2.1 kgf•cm)
Apply Screw lock after tightening screws.
Note: Keep Camera support 12 pressing towards the direction of the arrow, then secure with the screws in the upper.
9-2.
Install Fan bracket 7 to the unit reassembled in Step 9-1, then tighten Screws 104 (x2).
Torque: 21.2 cN•m (2.1 kgf•cm)
Keep pressing towards
the direction of the arrows
to secure with the screws.
12
Camera
support
104
104
Screws
2x4 mm (x2)
Install Camera support 12 , while viewing the unit reassembled in Step 9-2 from the front, to the left side, then tighten
9-3.
Screws 104 (x4).
Torque: 21.1 cN•m (2.1 kgf•cm)
Note1: Keep Camera support 12 pressing towards the direction of the arrow to secure with the screws 104 (x4).
9-4.
Install Fan motor ass'y 153 to the unit reassembled in Step 9-3, then tighten Screws 105 (x2).
Note1: Make sure of the direction of Air flow and the lead wires of Fan motor ass'y 153 .
Note2: Do not tighten the screws 105 (x2) too much, otherwise Fan motor ass'y 153 may be damaged.
Torque: 15 cN•m (1.5 kgf•cm)
12
Camera support
Figure of Step 9-3
64
Camera
Figure of Step 9-1
105
Keep pressing towards
the direction of the arrows
to secure with the screws.
7
Fan bracket
104
Screws
2x4 mm (x2)
104
Screws
2x4 mm (x4)
104
153
Fan motor ass'y
Screws
2x12 mm
(x2)
The direction of Air flow
–29–
Figure of Step 9-2
The direction of Lead wires
Figure of Step 9-4
Advertisement
Table of Contents
