Lamp Axis Adjust; Adjust X, Y, & Z Lamp Axis - Sony LMT-300 User Manual

The Lamp Serial Code is included with the replacement
(new) lamp. To enter the Lamp Serial Code tap the text
box. An on-screen numeric keyboard appears.
Cancel
Using the on-screen keyboard, tap the numeric Serial
Code and then tap Enter. The Serial Code is validated for
correct format and Next becomes available. Tap Next to
continue to Lamp Axis Adjust.
To cancel Serial Code entry, if any entry has been made
into the Serial Code text box tap Clr, then tap Enter, and
then tap Cancel. If no entry has been made into the Serial
Code text box simply tap Enter and then tap Cancel. In
either case, a popup confirmation appears. Tap Yes and the
Lamp Install Wizard closes.
Note: The lamp should be replaced prior to exceeding
recommended operating hours. Refer to the projector
documentation for additional information.

Lamp Axis Adjust

The Lamp Axis Adjust entry feature has been made
available under the "trsetup" login and combined with
other functions, i.e., Lamp Serial Code entry and Image
1
Registration . Previously, Lamp Axis Adjust required
using the SRX Controller application.
Note: Lamp Axis Adjust is only available through the
pre-defined Theater Setup login thus insuring that this
adjustment is only done by qualified personnel.
Adjust X, Y, & Z Lamp Axis
Installation of a new lamp is a multistep process and once
the lamp is installed the Lamp Axis (X, Y, and Z) must be
adjusted for optimum light output.
1.In previous versions, Image Registration required use of
the SRX Controller application.
Normally, the Lamp Axis
Adjust process is
performed following
Lamp Installation and
Serial Code Text Box
setting the Lamp Serial
Code. In this case the
Lamp Install wizard will
automatically progress
from Serial Code entry to
Axis Adjust. However, if
the axis adjustment
cannot be performed at
the time of installation
you can directly access
the Lamp Axis Adjust
steps using the "trsetup"
login.
Note: During Lamp Axis Adjust the rear door on the
Next
Projector must be unlocked and open to allow access to the
X and Y adjustment screws. The rear panel on the Lamp
Housing is closed and secured. For additional information
refer to the Projector Service Manual.
The Wizard automatically checks for the correct Projector
Power mode of operation, e.g., Lamp Axis Adjust requires
LAMP ON mode. For Lamp Axis adjustment the Lamp
should be on for an amount of time (approximately 5
minutes) to insure stability of the lamp output. A
countdown timer has been included to indicate how much
time remains before axis adjustment can begin.
The Lamp Axis Adjust "wizard" (initial screen shown
below) begins the process of entering the Lamp Serial code
for the new (replacement) lamp.
To proceed to Lamp Axis Adjust click Next. Step 1 of 4
appears.
1
Tap Lamp Axis Adjust
Cancel
The Lamp Axis Adjustment wizard will automatically
establish the Lamp at 100% Power and select the
"Black" test pattern. A countdown timer is also
displayed on this screen By waiting for this timer to
Tap Menu
Tap Projector
Next
58
Theater Setup