ABB SmartMedia SM2000 Hardware Installation page 6

...3 Fitting Media Board
Sub-Assembly – Figs. 3.1 to 3.7
11) Fit the new media board sub-assembly – see Fig. 3.5.
12)Refit the PCB locking bar and chassis top cover –
see Fig. 3.7.
Refit PCB locking bar
1
ensuring the slots
in the bar locate correctly
on the boards and chassis
13)Refit the instrument to the case – see Fig. 3.1.
14)Restore the power supply to the instrument.
6
Caution. When positioning the
chassis top cover, take care not to
damage the EMC contacts.
5
Fig. 3.7 Refitting the PCB Locking Bar and Chassis Top Cover
EMC Contacts
Slide forward
Refit pozidriv screws
5
(one each side)
3
2
Position top cover as shown
4 Lower rear