Advertisement
Mounting the Kit to the
Machine
1. Install the rear mount assembly to the right side panel
on the machine using 2 bolts (3/8 x 7/8 inch) and 2
nuts (3/8 inch) as shown in
Note: Use the 2 front holes if you are mounting a
curved trimmer.
1. Bolt (3/8 x 7/8 inch)
2. Rear mount assembly
Figure
5.
Figure 5
3. Nut (3/8 inch)
4. Use these holes if you
are mounting a curved
trimmer.
2. Install the front mount assembly over the frame, near
the right caster wheel, using the wide-flange nut (3/8
inch) and carriage bolt (3/8 x 3 inches) as shown in
Figure
6.
1. Wide-flange nut (3/8 inch)
2. Front mount assembly
g038084
4
Figure 6
3. Carriage bolt (3/8 x 3
inches)
g038085
Advertisement
