Setup; Installing The Pto Driveshaft To An Optional Mower Deck Or Qas; Loose Parts - Toro Groundsmaster 360 31223 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Engine owner's manual
Declaration of Conformity
Ignition keys
1
Installing the PTO
Driveshaft to an Optional
Mower Deck or QAS
Parts needed for this procedure:
1 PTO driveshaft
4 Bolt (5/16 x 1-3/4 inches)
4
Locknut (5/16 inch)
2 Roll pin (3/16 x 1-1/2 inches)
Procedure
Note:
Installing the PTO driveshaft is easier if you
position the machine on a hoist.
Description
PTO driveshaft
Bolt (5/16 x 1-3/4 inches)
Locknut (5/16 inch)
Roll pin (3/16 x 1-1/2 inches)
Retainer pin
Grease fitting
Washer head screw (5/16 x 7/8 inch)
No parts required
No parts required
No parts required
Qty.
1
4
4
2
2
2
2
–
–
–
Qty.
1 Review it before operating the machine.
1 Use it to reference engine information.
1
2 Start the engine.
1. Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove
the key.
WARNING
If you start the engine and allow the PTO
to rotate, serious personal injury and
machine damage could result.
• Do not start the engine and engage the
PTO switch when the PTO driveshaft
is disconnected from the cutting deck.
• Before you disconnect the PTO
driveshaft from the cutting
deck, disconnect the PTO
solenoid-valve-coil connector
from the wire harness to prevent
unintentionally engaging the PTO
clutch.
2. Disconnect the wire-harness connector from the
PTO solenoid-valve-coil connector
12
Use
Install the PTO driveshaft to a optional
deck or QAS.
Use the hardware to install the optional
mower deck.
Adjust the roll bar.
Check the tire pressure.
Check the hydraulic fluid, engine oil,
and coolant levels.
Use
(Figure 3).