Maintenance; Maintenance Safety; Recommended Maintenance Schedule(S) - Toro Groundsmaster 360 31223 Operator's Manual

Maintenance

Note:
Determine the left and right sides of the machine from the normal operating position.
Download a free copy of the electrical or hydraulic schematic by visiting www.Toro.com and searching for your
machine from the Manuals link on the home page.

Maintenance Safety

•
Before adjusting, cleaning, repairing, or leaving
the machine, do the following:
– Park the machine on a level surface.
– Move the throttle switch to the low-idle position.
– Disengage the cutting units.
– Lower the cutting units.
– Ensure that the traction is in neutral.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all moving parts to stop.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 10 hours
After the first 50 hours
After the first 200 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 150 hours
Every 200 hours
Every 250 hours
Maintenance Procedure
• Check the tension on the alternator belt.
• Check the belt tension on the air-conditioning compressor.
• Torque the wheel-lug nuts.
• Change the engine oil and filter.
• Change the hydraulic fluid and filter.
• Test the safety-interlock system.
• Check the engine-oil level.
• Drain water or other contaminants from the water separator.
• Check the engine-coolant level.
• Clean the radiator with compressed air (do not use water). Clean the radiator more
frequently in extremely dusty and dirty conditions.
• Check the level of the hydraulic fluid.
• Clean the attachment.
• Grease the bearing and bushing grease fittings. Grease the bearing and bushing
grease fittings more frequently in extremely dusty and dirty conditions.
• Check battery cable connections.
• Check the tire pressure.
• Clean the air-conditioning coil. Clean the air-conditioning coil more frequently in
extremely dusty or dirty conditions.
• Check the tension on the alternator belt.
• Check the belt tension on the air-conditioning compressor.
• Change the engine oil and filter.
• Inspect the cooling-system hoses and seals. Replace them if they are cracked or
torn.
• Torque the wheel-lug nuts.
• Clean the cab air filters; replace them if they are torn or excessively dirty.
– Allow machine components to cool before
performing maintenance.
•
If the cutting units are in the transport position, use
the positive mechanical lock (if available) before
you leave the machine unattended.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Use jack stands to support the machine or
components when required.
•
Carefully release pressure from components with
stored energy.
31