Specifications - Bosch GCD 12 JL Professional Original Instructions Manual

Symbols and their meaning
Wear safety goggles.
Wear a dust mask.
Take note of the dimensions of the saw
blade. The hole diameter must fit the tool
spindle without play.
If it is necessary to use reducers, ensure
that the dimensions of the reducer are
suitable for the base blade thickness and
the saw blade hole diameter, as well as
the tool spindle diameter. Wherever pos-
sible, use the reducers provided with the
saw blade.
The saw blade diameter must match the
information specified on the symbol.
Product description and

specifications

Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended use
The power tool is intended for stationary use with saw
blades to make straight cuts with and against the grain, as
well as mitre angles up to 45° in metal materials without the
use of water.
Product features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Locking lever
(2) Laser protection cap
(3) Spindle lock
Retracting blade guard
(4)
(5) Chip box
(6) Angle guide
(7) Locking spindle
(8) Quick release
(9) Spindle handle
(10) Clamping lever of the saw table extension
(11) Saw table extension
Bosch Power Tools
(12) Hex key (6 mm)/cross-headed screwdriver
(13) Clamping handle for mounting the angle guide
(14) Transport safety lock
(15) Protective guard
(16) Handle
(17) On/off switch
(18) Laser warning label
(19) On/off switch for laser (cutting line indication)
(20) Transport handle
(21) Cover plate
(22) Bracket
(23) Mounting holes
(24) Chip drawer
(25) Saw table
(26) Lower fastening screw (cover plate/retracting
blade guard)
(27) Upper fastening screw (cover plate/retracting
blade guard)
(28) Guide bolt
(29) Hex socket screw for mounting the saw blade
(30) Clamping flange
(31) Saw blade
(32) Inner clamping flange
(33) Angle indicator
(34) Scale for mitre angles
(35) Set screw for laser positioning (parallelism)
(36) Screw for angle indicator
(37) Laser beam output
Technical data
Metal cut-off saw
Article number
Rated power input
No-load speed
Laser type
Laser class
Laser line divergence
Weight according to EPTA-
Procedure 01:2014
Protection class
Dimensions of suitable saw
blades
Max. saw blade diameter
Base blade thickness
English | 13
GCD 12 JL
3 601 M28 0..
W 2000
-1
min 1600
nm 650
mW < 0.39
1M
mrad (full 1.0
angle)
kg 20
/ II
mm 305
mm 1.8 − 2.5
1 609 92A 59S | (09.07.2019)