Table of Contents
Advertisement
FIxING THE ANCHOR SCREWS
•
Check the ceiling material and the thickness of the finish material. The anchor screws can only be used if
the ceiling is made of concrete. Do not mount the device on ceilings made of plaster board or medium-
density fiberboard (MDF).
1
4
Drill a hole 45 mm–55 mm deep using a 14.5-mm drill bit at the position you want to install your
1
anchor.
Clean out the drilled hole.
2
Insert an anchor screw into the hole.
3
Place the ceiling mount close to the ceiling so it matches the position of the screws.
4
Fasten the washers and nuts in order. Tighten the screw using a recommended torque of 45 kgf/cm
5
or more.
Tighten the washers and nuts until they are completely fastened.
6
2
5
Washer/
3
6
Nut
15
Anchor screw for
ceiling mount
Advertisement
Table of Contents
