Switching The Hands-Free Kit On/Off; Establishing Connection With Compatible Mobile Phones - Silvercrest SFA 4.1 E1 Operating Instructions And Safety Instructions

SilverCrest SFA 4.1 E1
The LED of the car charger adapter lights up green. The standby button (8) lights up green while charging. A full
charge cycle takes approximately 3 hours. The standby button (8) will go out when charging is complete. Disconnect
the car charger adapter from the in-car socket and the hands-free kit.
CAUTION! Charge the battery only when the engine is running to save your vehicle's battery.
The battery can also be charged on a PC or using an external mains adapter. A connecting cable with appropriate
micro-USB plug is required for this.

9.2 Switching the hands-free kit on/off

Press the standby button (8) for about three seconds until you hear a series of beeps and buttons 3, 4, 5 and 8 flash
briefly several times. The hands-free kit is now ready for use. If a connected device is in range, buttons 3, 4, 5 and 8
will flash blue briefly once about every ten seconds. If no connected device is in range, the device goes into
search/pairing mode.
To switch the hands-free kit off, hold down the standby button (8) for about two seconds. A beep sounds, button 3
flashes orange briefly several times and then goes out completely.

9.3 Establishing connection with compatible mobile phones

Pairing/Connecting
Only on first use and following a reset to factory settings, the hands-free kit will start directly in pairing mode after
holding down the standby button (8) for about three seconds. The mute button (3) will flash alternately orange and
blue.
English - 13