Tm15 Terminal Module; Terminal Module Tm120 - Siemens NCU 7x0.3 PN Series Manual

9.6

TM15 Terminal Module

Properties
Terminal Module TM15 provides drive-related digital inputs and outputs with short signal
delay times. TM15 is connected by means of DRIVE-CLiQ.
Each of the 24 isolated DI/DOs can be parameterized channel-by-channel as a digital input
(DI) or digital output (DO).
Additional references
You can find additional information on the TM15 in the SINAMICS S120 manual titled
"control units and Additional System Components".
CAUTION
The cooling clearances of 50 mm above and below the component must be observed.
9.7

Terminal Module TM120

Properties
The TM120 is a DRIVE-CliQ component, which is used to provide protective separation for
temperature sensors for 1FN, 1FW6 motors, to protect these motors against
overtemperature. The motor temperature is acquired via 4 channels with different
temperature sensors. Encoder evaluation functions are performed via Sensor Modules (e.g.
SMCxx, SMExx). This means that, when connected to a Sensor Module SMCxx, the TM120
represents an alternative control cabinet to the SME120/SME125.
The component can be snapped onto mounting rails in control cabinets.
NOTICE
The Terminal Module TM120 cannot be operated with a SINAMICS S120 Combi.
Additional references
You can find additional information on the TM120 in the SINAMICS S120 manual titled
"Control Units and Additional System Components".
CAUTION
The cooling clearances of 50 mm above and below the component must be observed.
NCU 7x0.3 PN
Manual, 09/2011, 6FC5397-1EP40-0BA0
Connectable components
9.6 TM15 Terminal Module
157