Connecting Profibus Dp - Siemens NCU 7x0.3 PN Series Manual

Connecting
7.8 PROFIBUS DP
7.8.5

Connecting PROFIBUS DP

Introduction
PROFIBUS cables are connected to the X126/X136 interface by means of a bus connector.
Wiring the bus connector
1. Proceed as follows to connect the bus connector:
2. Plug the bus connector into the corresponding interface on the control unit.
3. Screw the bus connector into place.
Figure 7-10
Note
Make sure that the stations on which the terminating resistor is located are always
supplied with voltage during booting and operation.
66
As the control unit is located at the start or end of a segment, you must switch on the
terminating resistor ("ON" switch setting).
Terminating resistor switched on and off
NCU 7x0.3 PN
Manual, 09/2011, 6FC5397-1EP40-0BA0