Updating Packages - NEC Express5800 Series Installation Manual

Chapter 1 Installing Operating System

2.2.5 Updating packages

Follow the steps below to update packages.
1. Store the package you have downloaded from Red Hat Network in the desired directory, and go to
that directory.
2. Make sure that package files are properly downloaded.
Compare the MD5 checksum described in Red Hat Network with the output result of command shown
below. If they match, files are successfully downloaded.
# md5sum kernel-2.6.32-431.17.1.el6.x86_64.rpm
# md5sum kernel-devel-2.6.32-431.17.1.el6.x86_64.rpm
# md5sum kernel-doc-2.6.32-431.17.1.el6.noarch.rpm
# md5sum kernel-firmware-2.6.32-431.17.1.el6.noarch.rpm
# md5sum openssl-1.0.1e-16.el6_5.14.x86_64.rpm
# md5sum openssl-devel-1.0.1e-16.el6_5.14.x86_64.rpm
3. Run the following command to update packages.
# rpm -Uvh kernel-firmware-2.6.32-431.17.1.el6.noarch.rpm
# rpm -Uvh kernel-2.6.32-431.17.1.el6.x86_64.rpm
# rpm -Uvh kernel-doc-2.6.32-431.17.1.el6.noarch.rpm
# rpm -Uvh kernel-devel-2.6.32-431.17.1.el6.x86_64.rpm
# rpm -Uvh openssl-*
4. Run the following command to reboot the system.
# reboot
42
Express5800/R320c-E4, R320c-M4 Installation Guide (Linux)
2. Setting up Red Hat Enterprise Linux 6 Server